The Alula RE207 is a wireless outdoor door and window security transmitter that is compatible with Honeywell Home security systems. The RE207 outdoor contact is designed to sense the opening and closing of gates, sheds, and other outdoor open/close applications. An alarm signal will be transmitted when the magnet is pulled away from the sensor, or when an external contact is opened.
To enroll the RE207, begin by either entering their serial numbers into the Honeywell Home security panel. Alternatively, the sensor can be enrolled by placing the panel into wireless enrollment mode and either removing the battery tab while holding the tamper, or by tripping the device three times. These sensors must be enrolled as a "Loop 2" sensor.
To install the RE207, begin by first attaching the mounting plate and magnet to a door, window, or fence using screws (provided) or cable ties (not provided). Make sure to align the alignment marks on the sensor and magnet when mounting. Finish by latching the sensor to the mounting plate and tightening the cover securing screw to secure the sensor in place.
Removal Tamper is implemented by screwing the provided screw with rubber washer through the removal tamper screw hole in the base and into the mounting surface. Remove the battery for access to the removal tamper screw hole. External Contacts can be installed by routing the wires through the back of the enclosure. A thinned area in the enclosure must be punched out with a screwdriver to allow the wires through. After routing and connecting the wires, reseal the hole with silicone caulk.
External Contacts can be installed by routing the wires through the back of the enclosure. A thinned area in the enclosure must be punched out with a screwdriver to allow the wires through. After routing and connecting the wires, reseal the hole with silicone caulk.
Product Features:
Industry-leading wireless 345 MHz range and battery life
