Please Note: The Alula RE107 wireless outdoor door/window alarm contact for GE Interlogix has been discontinued without replacement.
The Alula RE107 is a wireless outdoor door and window security transmitter that is compatible with GE® and Interlogix® security systems. The RE107 outdoor contact is designed to sense the opening and closing of gates, sheds, and other outdoor open/close applications. An alarm signal will be transmitted when the magnet is pulled away from the sensor, or when an external contact is opened.
To enroll the RE107, begin by either entering their serial numbers into the GE or Interlogix security panel. Alternatively, the sensor can be enrolled by placing the panel into wireless enrollment mode, and then pulling the battery tab or tampering the device.
To install the RE107, begin by first attaching the mounting plate and magnet to a door, window, or fence using screws (provided) or cable ties (not provided). Make sure to align the alignment marks on the sensor and magnet when mounting. Finish by latching the sensor to the mounting plate and tightening the cover securing screw to secure the sensor in place.
Removal Tamper is implemented by screwing the provided screw with rubber washer through the removal tamper screw hole in the base and into the mounting surface. Remove the battery for access to the removal tamper screw hole. External Contacts can be installed by routing the wires through the back of the enclosure. A thinned area in the enclosure must be punched out with a screwdriver to allow the wires through. After routing and connecting the wires, reseal the hole with silicone caulk.
External Contacts can be installed by routing the wires through the back of the enclosure. A thinned area in the enclosure must be punched out with a screwdriver to allow the wires through. After routing and connecting the wires, reseal the hole with silicone caulk.
Product Features:
- Industry-leading wireless 319.5 MHz range and battery life
- Compatible with GE and Interlogix security systems
- Two built-in external contact zones
- Secure encrypted wireless transmissions
- IP67 waterproof enclosure rating
- Cover tamper
- Strong, reliable RF signal
- 10 year battery life on CR123A battery
- 5 year warranty
Physical
- Housing Dimensions: 3.3 x 1.3 x 2.8 inches (8.4 x 3.3 x 7.1 cm)
- Weight with Battery: 5.7 ounces (161.6 grams)
- Mounting Fastener: Four 1 inch stainless steel screws (provided)
- Removal Tamper Fastener: One 1-1/4 inch stainless steel screw with rubber washer (provided)
Environmental
- Operating Temperature: -40 to 158°F (-40 to 70°C)
- Maximum Humidity: 100% relative humidity
- Ingress Protection Rating: IP67
Sensor Specifications
- Frequency: 319.5 MHz
- Replacement Battery: One Panasonic® CR123A Lithium Battery
- Nominal Battery Life: 10 years
- Battery Voltage: 3.0 VDC (Nominal), 2.2 VDC (Low)
- Current Draw: 20 mA (Maximum), 0.6 uA (Quiescent)
- Transmitted Indications: Cover Tamper, Removal Tamper, Low Battery, Supervision
- Max Wire Length on External Contacts: 7.5 feet
- Certification: FCC, IC