The Resideo Honeywell Home PROSiXPANIC is a wireless bi-directional panic sensor that is intended for use with control panels that support PROSiX-Series devices. The PROSiXPANIC 2-button wireless sensor is compatible with the ProSeries PROA7, ProSeries PROA7C, ProSeries Canada PROA7CN, ProSeries PROA7PLUS, ProSeries PROA7PLUSC or ProSeries Canada PROA7PLUSCN all-in-one wireless touchscreen control panels.
The PROSiXPANIC wireless sensor is simple to activate, just press and hold both buttons briefly until the LED flashes. To clear the alarm at the control, enter a user code. To clear memory of alarm, select Disarm and enter a user code. The PROSiXPANIC has the following LED indications; Green Flashing lights when unit is transmitting, Red Flashing lights indicate low battery (lights during button press).
To enroll the PROSiXPANIC, set the controller in Programming Mode, press and hold the button for about 3 seconds until the LED flashes green to activate the enrollment process. The LED flashes green during enrollment and the device sends its unique MAC ID (Serial Number) and Services information to the controller. When done, the LED lights solid green for 3 seconds to confirm enrollment. Once enrolled, verify adequate signal strength by conducting a sensor test. Please note, the PROSiXPANIC cannot be used with another system until it is removed from the current controller. When removed from a system, the PROSiXPANIC will revert to factory default settings.
If the device is enrolled in a panel different than the intended panel, and you are unable to delete it from the unintended panel, reset the device to factory default setting: Press and hold both buttons for 15 seconds. When successful, the LED comes back on flashing. The PROSiXPANIC device self-deletes from the panel it was enrolled in. This procedure is available for 24 hours after enrollment with a panel and the device remains powered (battery installed).
